Worktop replacement in Marbella
If the new worktop is thinner, the joint with the covering is not necessarily at the same height. A mark or an unfinished section that was previously covered may appear. This difference must be observed along with the supports and appliances, before confirming a piece solely by its finish.
Tell us about your kitchen
Choose the type of renovation and the approximate size. Then write to us or fill out the form.
Supports, gaps and joints of the piece
- MeasurementUnderstand the measurements and where the piece rests.
- MaterialsCompare finishes thinking about daily use.
- DisassemblyPlan how the existing surface will be removed.
- SinkCheck the sink before cutting the piece.
- HobCheck gap and assembly.
- AuctionsDefine edges and tufts.
- InstallationPlace the new worktop.
- final finishCheck joints and seals.
Worktop replacement quote in Marbella
Preserved furniture needs a level reference
The surface measurement is prepared with the cabinets in the position that will receive the material. If there is a deteriorated support or an unevenness, the adjustment of the furniture must be made. Changing the thickness does not resolve this condition and can add adaptations that should be separated from the placement of the worktop. See also: furniture adjustment.
The finishing with the tiling is part of the replacement
The proposal must explain whether the covering is preserved, a piece is added or a larger area is intervened. The tiling work may be different depending on the strip that is visible. Having this limit defined allows you to compare materials while also knowing how the remaining wall will be finished.
Quote and scope of work at Marbella
A different thickness changes assembly dimensions and joints, so we evaluate possible support adjustments and the strip of wall that may remain visible.
